For puncture and injection of drugs for epidural anesthesia into the patient's epidural space. Available with epidural needles with stainless steel or polypropylene stylet.
Specifications:
- Complete set: epidural needle, stylet and protective tube;
- Graduation along the entire length of the needle in 1 cm increments;
- Needle sizes: 16G (1.6mm); 17G (1.4mm); 18G (1.2mm); 19G (1.1mm); 20G (0.9mm);
- Needle length: 3 ¼ (80mm) and 3 ½ (90mm);
- It has a removable stop bar for fingers;
- The term of use is 5 years from the date of manufacture indicated on the package;
- Sterile, non-pyrogenic, non-toxic;
- For single use;
- Individual packing.
Instructions for use:
- Remove the product from the packaging, check its integrity;
- Conduct proper antiseptic treatment of the puncture site;
- For a conventional epidural procedure, needle entry into the epidural space can be determined using a resistance loss syringe connected to the epidural needle pavilion. The stylet must be removed prior to contact with the ligamentum flavum. To determine the position of the needle, the user must also pay attention to the graduations on the needle;
- The introduction of the anesthetic solution should be carried out at the same rate, depending on the intensity of diffusion of the anesthetic drug. At the same time, it is necessary to constantly monitor the patient's condition in accordance with the requirements for epidural anesthesia;
- After the injection is completed, the epidural needle must be removed;
- At the end of the manipulation, dispose of the product in accordance with the established norms.
